URC6820: How can I search through the codes in the memory of my Zapper +?

To search through all TV codes in the memory of your Zapper +:

  1. Make sure your TV is turned on.
  2. Hold down the TV POWER and STB POWER keys until the light blinks once and then twice.
  3. Press and release the OK key.
  4. The remote will now send a Power function automatically every three seconds.
  5. As soon as the device turns off, press the OK key to store the code. The LED will blink twice to confirm.

To search through all STB codes in the memory of your Zapper +:

  1. Make sure your STB device is turned on.
  2. Hold down the Volume Up and Channel Up keys until the light blinks once and then twice.
  3. Press and release the OK key.
  4. The remote will now send a Power function automatically every three seconds.
  5. As soon as the device turns off, press the OK key to store the code. The LED will blink twice to confirm.

To search through all AMP codes in the memory of your Zapper +:

  1. Make sure your Audio device is turned on.
  2. Hold down the Volume Down and Channel Down keys until the light blinks once and then twice.
  3. Press and release the OK key.
  4. The remote will now send a Power function automatically every three seconds.
  5. As soon as the device turns off, press the OK key to store the code. The LED will blink twice to confirm.

Additional Information:

  • If the full load of codes has been tested unsuccessfully, the LED will blink three times and the remote will exit programming mode.