URC7880: How do I program my code on my Smart Control?

To program the basic code on your Smart Control remote, please follow the instructions mentioned below:

1. Hold down MAGIC until the light blinks once and then twice and stays lit.
2. Use the DEVICES key to select the relevant device mode.
3. Enter the code, the light will blink twice and turn off.
4. You can now operate your device.

If the LED does not blink twice at the end, please try the following:

1. Hold down MAGIC until the light blinks once and then twice and stays lit.
2. Use the DEVICES key to select the relevant device mode.
3. Enter 992, the light will blink twice.
4. Press the Magic key once, the light blinks once.
5. Press the Magic key again, the light will blink twice and turn off.
6. You can now set up the device code.